Test the cellular failover connection by unplugging the wired connection or by using the traceroute tool under Security & SD-WAN > Monitor > Appliance Status in the Tools tab The connection will say Ready when it is successfully connected When the cellular uplink is successfully connected, you will be able to see the status on the left hand side of the Appliance Status page and in the Uplink tab. Navigate to Security & SD-WAN > Monitor > Appliance Status > Uplink tab and next to Status, select the edit (pencil) button and then select Enabled. If so, do that from the Meraki Dashboard under Security & SD-WAN > Monitor > Appliance Status > Uplink tab Power on the MX and wait for the MX to show as online in the Meraki dashboardĬheck with the carrier of choice if an APN needs to be configured. Insert a nano SIM card (4FF size) and close the SIM trayĬonnect the uplink for the MX device via a wired connection to connect to the Meraki cloud Open the SIM tray using the SIM card removal tool included in the box

Power off the MX. Swapping/installing SIM cards while the MX is powered on may cause unexpected behavior or errorsįor the MX67C, connect the antennas for cellular reception.

To set up the cellular failover connection, follow the steps below: The IMEI of the MXs with embedded LTE, as well as the serial number and MAC address, can be found on the product label at the bottom of cellular-embedded MX devices. Note that the IMEI cannot yet be found on the Meraki dashboard, only on the physical label of the device.

Mount whitney mx mx sim